In a project, the extract that shows activity is split step by step, and each fraction is tested again, so that effort goes only into the active part. Markers check two things: that the masses add up, and that the yields are reported against the right starting weight.
Data. 500 g of dried, powdered leaves give 50 g of crude methanol extract. The crude extract is suspended in water and partitioned with solvents of increasing polarity.
| Fraction | Mass (g) | DPPH activity |
|---|
| Hexane | 12.5 | Weak |
| Ethyl acetate | 9.0 | Strongest |
| n-Butanol | 11.5 | Moderate |
| Remaining water layer | 15.0 | Weak |
| Total recovered | 48.0 | |
Step 1: crude extract yield. 50 ÷ 500 x 100 = 10% of the dry plant.
Step 2: recovery after partitioning. 12.5 + 9.0 + 11.5 + 15.0 = 48.0 g, so recovery is 48.0 ÷ 50 x 100 = 96%. The missing 4% is solvent loss and material left on glassware; recovery well below 90% suggests a mistake.
Step 3: isolate. Column chromatography of the ethyl acetate fraction gives 45 mg (0.045 g) of a pure compound.
Step 4: report the yield three ways.
| Yield against | Calculation | Result |
|---|
| The ethyl acetate fraction | 0.045 ÷ 9.0 x 100 | 0.5% |
| The crude extract | 0.045 ÷ 50 x 100 | 0.09% |
| The dry plant material | 0.045 ÷ 500 x 100 | 0.009% w/w |
The figure that matters for comparison with the literature is the last one, based on dry plant weight. State which basis you use every time.
Common slips: testing fractions at different concentrations, so activity cannot be compared; forgetting a solvent-only control; and claiming a compound is "the active principle" when only the fraction was tested.