Many drugs are weak organic bases that give no sharp end point in water. In anhydrous acetic acid, perchloric acid behaves as a very strong acid and the drug as a stronger base, so the end point becomes sharp. The end point is found with crystal violet or potentiometrically.
Deriving the factor. For a base that takes up one proton, 1 mL of 0.1 M perchloric acid contains 0.1 mmol of acid and reacts with 0.1 mmol of base. For a drug of molar mass 171.15 g/mol, such as metronidazole, that is 0.1 × 171.15 = 17.115 mg per mL. A monograph prints this rounded figure; you should be able to work it out.
Illustrative assay. 300.0 mg of drug in anhydrous acetic acid needs 17.65 mL of 0.1 M perchloric acid. A blank titration of the solvent alone needs 0.15 mL. The perchloric acid has a factor of 0.998.
| Step | Working | Result |
|---|
| Net titre | 17.65 − 0.15 | 17.50 mL |
| Drug found at nominal strength | 17.50 × 17.115 | 299.51 mg |
| Corrected for the factor | 299.51 × 0.998 | 298.91 mg |
| Content | 298.91 ÷ 300.0 × 100 | 99.64% |
| Calculated on the dried substance (loss on drying 0.32%) | 99.64 ÷ (1 − 0.0032) | 99.96% |
Leaving out the blank gives 17.65 × 17.115 × 0.998 ÷ 300.0 × 100 = 100.49%, which can push a result outside a 99.0–101.0% limit. Acetic acid expands noticeably with heat, so record the temperature, and correct the titrant volume if the room temperature differs from the temperature at which the perchloric acid was standardised.